Eigenbau HV-Kondi
|
July 25, 2014, 10:19 AM
|
|
I want to build me testing jobs a HV Kondi myself, but I found still no manual for this. I was thinking about a plate Kondi. Can you help me? A Word to the (at the time in the book seem to be out): GOOGLE. I've done a picture tutorial for the Kondis, which I used for my Marx 2-3, I should upload it where Plattenkondis are very easy to make, google times or ask George in Forum, used it with success for his SGTCs. I got mine just flux ne first bottle built. When I connect the bottles and don't give 2 kV, the aluminum foil around the bottle moves. Is this normal?
The bottle consists of a stainless steel rod electrode, salt water and the ALU-foil a 1.5 l PET bottle of silvered, outdoor rum.
Also, it is important that HV electrical you on the aluminum foil and hence the salt water didn't reach the top, the end of the neck of the bottle are doing, because then there's rollovers. It's always the voltage on it, but already in place should be 5 cm. If you have then to a TC, there good rollovers you don't want above all else through the RF. NE, which are far too weak. Do a half-rectifier with 1N4007. How many of you werwenden there shall depend on the power source, with a stun gun range 3-5, I habs tried with one, went also, but is not the recommend. How am I the then boarded? 4 diodes as a bridge rectifier circuit (Zweiweggleichrichter) or as a half-wave Rectifier?
|
|
|